Three techniques to improve the performance of Flap disc. Flap disc are suitable for the polishing of stainless steel, metal, metallurgy, automobile, wood, marble and other industries. Impeller matrix with mesh, nylon, plastic, steel paper, etc., the number of pages are different, uniform fan distribution. Flap disc is especially suitable for stainless steel processing, can replace resin sequence sand wheel, it has a strong elasticity, high tensile bending strength, good self-sharpening, high grinding rate, low noise, suitable for box body welding seam send stamping flash grinding.

1. The right choice

The correct selection of Flap disc can ensure that Flap disc are maximized. The cutting force of a flap disc with good quality is relatively strong, which can adapt to the cutting treatment of materials with different strength. Its heat-resistant and wear-resistant characteristics can also finish large-scale equipment grinding and polishing, with strong hardness and service life is up to several times more than similar cutting products.

2. Enough pressure

Overuse can overload and overheat the blades, which can lead to faster blade wear and reduce the effectiveness of abrasives. At the same time, if there is not enough pressure to use, flap disc will not engage with the metal, not enough to effectively grind the surface, which will lead to longer grinding time and further wear.

3. The correct use

A hundred flaps are designed to work at an Angle. The Angle depends on what you're making and what you're grinding, however, generally in the flat/horizontal range of 5-10 degrees.If the Angle is too flat, too many blade particles will immediately connect to the metal, causing sanding disc to wear out faster. If the Angle is too high, the blade cannot be fully used. This will lead to excessive wear on some of the Flap disc and insufficient polishing.